Derma Pen Microneedle Therapy Machine
Dermapen Microneedle Therapy Machine
A derma micro-needle pen, also known as a dermapen, is a hand held device used for home beauty treatments. The equipment consists of a small plastic roller covered in small needles, which puncture the skin. Derma micro-needles are used to help remove skin blemishes, old acne scars, stretch marks and to rejuvenate the skin. Micro-needle rollers operate on the principle that by removing the epidermal skin, younger, fresher skin will grow back to take it's place.
Voltage: 5V=1000mA, 12VA
Input: AC100-240V, 50-60Hz
Weight pen: 82g
Micro needles length: 0.25.0.5.0.75.1.0 1.5 2.0mm
Speed: Stage 1~3
Product Specifications /Features
1. Minimal risks
2. Cost Effective
3. Short healing period
4. No permanent skin damage
5. No increase in sun sensitivity
6. Performed under topical anaesthesia
7. All skin types can be treated
8. Thin or pre-lasered skin can be treated
9. Body produces natural collagen for long-lasting results
10. Enhanced penetration of applied products
1. Scar removal including acne scar removal or treatment.
2. Stretch mark removal
3. Anti aging.
4. Anti wrinkle
5. Cellulite treatment/ cellulite reduction or removal.
6. Hair loss treatment/ hair restoration
7. Hyper pigmentation treatment.
Treatment time suggestion:
6-8 sessions recommended, with 4-6 weeks intervals.
-Visual and noticeable improvement in a few days from the first treatment
-Cost effective - there's no investment needed unlike equipments such as laser.
-Short healing time
-No permanent damage or injury
-No bruising, infection, discoloration or other complications
-Extremely high absorption of any active ingredients
-Almost all skin types can be treated
-Thickens the dermis without damaging or removing epidermis
1 Establish a sterile environment. Wash your hands thoroughly with soap and water, rubbing vigorously for about fifteen seconds. The area to be treated must then be washed thoroughly as well. Soak a new derma micro-needle roller in 70 percent alcohol disinfectant for two minutes before use. Fill a large glass with disinfectant and place the roller in the glass.
2 Numb the area with a topical anesthetic gel a before the procedure, if you prefer. This is not necessary. Applying this gel will allow you to use more pressure with the micro-needle. Follow the instructions on the bottle and apply the gel to the affected area.
3 Roll the device back and forth. This should be done four times in four strokes. Vertical, horizontal and diagonal on each side. Apply with slight pressure, if you decided to use an anesthetic gel, increase the pressure. The treatment should not cause pain but a tingling sensation may be felt. If blood is drawn, stop the procedure immediately.
4 Wash the treated area with cold water, and dry thoroughly. Apply moisturizer rich in Vitamin C and E. These vitamins help in collagen production.
5 Rinse the micro-needle with hot running water after used. If numbing cream was used with it, fill a large glass half full of disinfectant solution and leave it there for 30 minutes to one hour. Shake off excess liquid after use and leave it on a clean towel to dry.
6 Apply one treatment four to six times weekly for about two weeks, and then once every one to three months to maintain results.